Set Level - Dell Force10 Z9000 Reference Manual

none
additive
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
ip community-list
Commands
match community
neighbor send-community
show ip bgp community
show ip community-lists

set level

Configure a filter to specify the IS-IS level or OSPF area to which matched routes are redistributed.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax set level {backbone | level-1 | level-1-2 | level-2 | stub-
area}
To remove a set level condition, use the no set level {backbone | level-1 |
level-1-2 | level-2 | stub-area} command.
Parameters
backbone
level-1
level-1-2
level-2
296
All routes with the NO_EXPORT (0xFFFFFF01) community attribute
must not be advertised outside a BGP confederation boundary.
Enter the keyword none to remove the community attribute from
routes meeting the route map criteria.
(OPTIONAL) Enter the keyword additive to add the communities to
already existing communities.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– configures community access list.
– redistributes routes that match the COMMUNITY attribute.
– assigns the COMMUNITY attribute.
– displays BGP community groups.
– displays configured Community access lists.
Enter the keyword backbone to redistribute matched routes to the
OSPF backbone area (area 0.0.0.0).
Enter the keyword level-1 to redistribute matched routes to IS-IS
Level 1.
Enter the keyword level-1-2 to redistribute matched routes to IS-
IS Level 1 and Level 2.
Enter the keyword level-2 to redistribute matched routes to IS-IS
Level 2.