Copy Tftp Startup-Config - Avaya P330-ML-ML Reference Manual

The syntax for this command is:
copy tftp stack-config <filename> <ip>
filename
ip
Example (for Windows):
Router-N# copy tftp stack-config c:\config\switch1.cfg
192.168.49.10
Example (for Unix):
Router-N# copy tftp stack-config /folder/switch1.cfg
192.168.49.10

copy tftp startup-config

User level: supervisor
This command applies to the P334T-ML only when it is in "Layer2"
device mode.
Use the copy tftp startup-config command to download a startup
configuration from the saved TFTP file to the Startup Configuration file in the
NVRAM.
Only parameters that differ from the factory default settings for the switch are
included in the configuration file. Therefore, it is important to reinitialize the
NVRAM to the factory default settings before downloading configuration files
to the switch. To reinitialize the NVRAM, run the nvram initialize
command.
The syntax for this command is:
copy tftp startup-config <filename> <ip>
filename
ip
Example (for Windows):
Router-N (super) # copy tftp startup-config c:\P330-
ML\startup.cfg 149.49.100.41
Avaya P330-ML Reference Guide
Chapter 2
The file name (full path)
The IP address of the TFTP server
Destination file name in the tftp server (full path)
The ip address of the tftp server.
Avaya P330-ML Layer 2 CLI Commands
29