Checking triggered updates for RIP interfaces
Check whether automatic triggered updates for RIP–enabled interfaces is enabled or disabled.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. Enter the show ip rip command.
3. Observe and note the Triggered Update status for RIP interfaces.
Enabling triggered updates for RIP interfaces
Ensure that the automatic triggering of updates is enabled for RIP-enabled interfaces.
Procedure
1. Enter Interface Configuration mode:
enable
configure terminal
interface Ethernet <port> or interface vlan <1–4094>
2. Enter the ip rip triggered enable command.
A virtual router remains in the initialize state
This section describes the troubleshooting process you can use to diagnose and resolve a situation
where a virtual router that should be in either the Backup or Master operational state, remains in the
Initialize state.
Global IP routing status
Ensure IP routing is enabled globally for a switch or stack.
Checking the global IP routing status
Determine if IP routing is globally enabled or disabled.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. Enter the show ip routing command.
July 2015
Comments on this document? infodev@avaya.com
A virtual router remains in the initialize state
Troubleshooting Avaya VSP 7000 Series
91