Konica Minolta bizhub C658 Service Manual page 716

bizhub C658/C558/C458/C368/C308/C258
8. To reinstall, reverse the order of removal.
8.24.5 PI drive board (PIDB) (PI-507)
1. Remove the rear cover.
G.8.24.2 Rear cover (PI-507)
[1]
[1]
[1] [2] [1]
[1] [1]
4. To reinstall, reverse the order of removal.
8.24.6 PI operation board (PIOB) (PI-507)
1. Remove the operation panel cover assy.
G.8.24.3 Operation panel cover assy (PI-507)
[1]
[2]
3. To reinstall, reverse the order of removal.
8.24.7 PI relay board (PIRB) (PI-507)
• The removal process of the PI relay board (PIRB) is the same as the removal process of the ZU drive board (ZUDB) of the Z fold unit
ZU-609. Refer to the removal process of the ZU drive board (ZUDB)
ZU drive board (ZUDB) (ZU-609)
[2]
[1]
7. Remove the post inserter [1] by shifting it toward the direction of the arrow.
NOTE
▪ Install the post inserter so it is hooked to the positioning screw [2]
attached to the finisher.
2. Disconnect eight connectors [1] on the board.
3. Remove four board supports [1] and remove the PI drive board [2].
2. Remove two screws [1] and remove the PI operation board [2].
G-416
G DISASSEMBLY/REASSEMBLY > 8. Option