Konica Minolta bizhub C658 Service Manual page 904

bizhub C658/C558/C458/C368/C308/C258
(b) Procedure
<URL>
• To set the address of the http server.
<Account>
• To set an account that is used to access the http server.
<Password>
• To set a password that is used to access the http server.
<Port Number>
• To set a port number that is used to access the http server.
(2) SSL Settings
(a) Use
• To make SSL settings of the http server at the other end that is used in CS Remote Care.
(b) Procedure
• To set whether or not to use SSL communication.
(3) Data Initialization
(a) Use
• To initialize values in the server settings.
5.14.6 Product Auth. Settings
(1) Product Authentication
(a) Use
• To set whether or not to enable product authentication.
NOTE
▪ When changing this setting under the condition where http is used for CS Remote Care communication, you need to perform
RAM Clear and then initial transmission again.
(b) Default setting
• No
(c) Setting item
• Yes
• No
(2) WebDAV
(a) Use
• To set a WebDAV server for the product authentication.
(b) Procedure
<URL>
• URL: To set the address of the WebDAV server.
• Account : To set an account that is used to access the WebDAV server.
• Password : To set a password that is used to access the WebDAV server.
• Port Number : To set a port number that is used to access the WebDAV server.
(3) Register Manually
(a) Use
• To install the certificate to be used in product authentication.
(b) Procedure(LMS)
<LMS>
1. Call the Service Mode to the screen.
2. Touch [CS Remote Care] -> [Product Auth. Settings].
3. Touch [Register Manually] -> [LMS].
4. Touch [Start] to communicate with LMS (License Management System) and install the certificate.
5. Check that the "Install OK" message appears.
(c) Procedure (USB)
NOTE
In the following conditions, installation of the certificate from a USB memory is prohibited.
• [Administrator Settings] -> [Security Settings] -> [USB Connection Permission settings] is set to [Restrict].
• [Administrator Settings] -> [Security Settings] -> [USB Connection Permission settings] -> [Detail Setting] -> [External
Memory (Service)] is set to [Restrict].
• [Administrator Settings] -> [Security Settings] -> [Enhanced Security Mode] is set to [ON].
1. Connect the USB flash drive where the certificate obtained from LMS (License Management System) is stored to the USB port of MFP.
2. Call the Service Mode to the screen.
3. Touch [CS Remote Care] -> [Product Auth. Settings].
4. Touch [Register Manually] -> [USB].
5. Touch [Start] to install the certificate.
I ADJUSTMENT/SETTING > 5. SERVICE MODE
I-134