Konica Minolta bizhub C658 Service Manual page 347

bizhub C658/C558/C458/C368/C308/C258
[2] [3]
[1]
[1] [2]
[1]
7. To reinstall, reverse the order of removal.
5.4.10 MFP board (MFPB)
NOTE
▪ Never use the combination of the used MFP board removed from another machine and the original eMMC board or EEPROM. This
combination causes corruption of stored data. Note that the combination of the original MFP board and the used eMMC board or
EEPROM removed from another machine also causes the same problem.
▪ Do not replace the MFP board and the eMMC board or EEPROM with new ones at the same time.
1. Remove the lower rear cover.
G.5.2.20 Lower rear cover
2. Remove the protective sheet.
G.5.2.21 Protective sheet
3. Remove the hard disk (A).
G.5.3.9 Hard disk (A) Cover type
4. If an optional security kit SC-508 is mounted, remove the DSC board/2.
G.8.27.2 DSC board/2 (for back side) (SC-508) (bizhub C368/C308/C258)
5. If an optional dual scan document feeder DF-704 is mounted, remove the dual scan image processing board.
G.8.4.11 dual scan image processing board (DSIPB) (DF-704)
6. If an optional security kit SC-508 is mounted, remove the DSC board/1.
G.8.27.1 DSC board/1 (for front side) (SC-508) (bizhub C368/C308/C258)
7. If an optional FAX kit FK-514 is mounted, remove the FAX board.
G.8.32.1 FAX Kit (Line1), FAX Kit (Line2) (FK-514)
8. Remove the optional upgrade kit UK-211 if it is installed.
G.8.28.1 Upgrade kit (UK-211)
9. Remove the optional hard disk (B) HD-524 if it is installed.
G.8.33.2 Hard disk (B) (HD-524: Cover type) (bizhub C368/C308/C258)
[1]
G DISASSEMBLY/REASSEMBLY > 5. bizhub C368/C308/C258
4. Remove the harness from the wire saddle [1].
5. Disconnect connector [2], and remove the control panel front cover assy [3].
6. Remove two screws [1], and remove the machine condition monitor board [2].
10. Remove the harness from two wire saddles [1].
G-47