Konica Minolta bizhub C658 Service Manual page 991

bizhub C658/C558/C458/C368/C308/C258
▪ When the DC-LOOP detection test is selected and Start key is pressed, DT=0001 is shown in the title row in case of detecting
the DC-LOOP. If not detected, DT=0000 is displayed.
Contents of test
CML Relay
CTL Relay
TEL Relay
DC-LOOP Detect
Speaker
Outside Ring Send
Audio Response Send
• * RL501 mounts only the Japanese.
5.20.13 Fax Test-Dial Test
• Not used
5.20.14 Fax Test - Off-hook Test
• Not used
5.21 ADF
5.21.1 Original Stop Position
(1) Use
• To manually adjust the original stop position and the read position in each of the DF modes.
• When the result is Unable in the automatic adjustment of the original stop position.
(2) Procedure
(a) Sub Scanning Direction 1-Side
NOTE
▪ Before performing this adjustment, the feed zoom adjustment needs to be complete.
I.5.21.8 Feed Zoom
• DF reading chart (for 1-sided)
B
• DF reading chart (for Duplex)
I ADJUSTMENT/SETTING > 5. SERVICE MODE
IC201, IC202
RL201
RL501 *
I-221
Device to be tested