Konica Minolta bizhub C658 Service Manual page 621

bizhub C658/C558/C458/C368/C308/C258
[3]
[2]
[1]
15. To reinstall, reverse the order of removal.
8.14.20 Bundle eject motor (M10) (FS-534/FS-534SD)
1. Remove the finisher from the main body.
G.8.14.6 Finisher (FS-534/FS-534SD)
2. Remove the rear cover.
G.8.14.1 Rear cover (FS-534/FS-534SD)
3. When the saddle unit is attached, open the front door and pull out the saddle unit.
[2]
[1]
[1]
[1] [2]
[1]
[3]
[2]
13. Remove the rotating disk [1].
14. Remove two screws [2], and remove the pre-eject drive motor [3].
4. Remove two screws [1], and remove the exit tray [2].
5. Remove four screws [1], and remove the plate [2].
6. Disconnect the connector [1].
7. Remove seven screws [2], and remove the left lower cover [3].
NOTE
▪ When the saddle unit is attached, disconnect two connectors.
G-321
G DISASSEMBLY/REASSEMBLY > 8. Option