Konica Minolta bizhub C658 Service Manual page 681

bizhub C658/C558/C458/C368/C308/C258
[2]
[1]
[2]
[1]
[3] [2]
[4]
[1]
16. Reinstall the above parts following the removal steps in reverse.
8.19.23 Trail edge stopper motor/F (M12) (FS-537/FS-537SD)
1. Remove the rear cover.
Rear cover (FS-537/FS-537SD)
2. Remove the front lower cover.
G.8.19.7 Front lower cover (FS-537/FS-537SD)
3. Remove the left upper cover.
Left upper cover (FS-537/FS-537SD)
4. Remove the main tray (paper exit lower tray).
G.8.19.8 Main tray (Paper exit lower tray) (FS-537/FS-537SD)
[1]
[2]
13. NOTE
▪ During the procedure, be careful not to bend the plate [1] and the
mylar [2].
14. Disconnect the connector [1] and remove two screws [2].
15. Remove four screws [1], remove the belt [3] while sliding the metal plate [2],
then remove the trail edge stopper motor/R [4].
NOTE
▪ Place the belt [3] on the gear during installation.
5. Rotate the stapler transfer dial [2] to move the stapler [1] towards the rear until
the dial stops.
NOTE
▪ If the stapler rotated (tilted) at the rear of the finisher, move it forward
until it becomes straight and again move it backward.
G-381
G DISASSEMBLY/REASSEMBLY > 8. Option