Konica Minolta bizhub C658 Service Manual page 330

bizhub C658/C558/C458/C368/C308/C258
[1]
[1]
[1]
[1] [A]
[1] [2]
5.3.11 Main drive unit
1. Remove the drum unit.
F.7.1.1 Replacing the drum unit
2. Remove the rear right cover.
G.5.2.18 Rear right cover
3. Remove the lower rear cover.
G.5.2.20 Lower rear cover
4. Remove the scanner rear cover.
G.5.2.1 Scanner rear cover
5. Remove the upper rear cover.
G.5.2.22 Upper rear cover
6. Open the PWB box.
G.5.3.10 How to open the PWB box
7. Remove the high voltage unit.
G.5.4.8 High voltage unit (HV)
8. Remove the transport motor.
G.5.5.1 Transport motor (M1)
9. Remove the PC motor.
G.5.5.2 PC motor (M2)
10. Remove the developing motor.
G.5.5.14 Developing motor (M21)
[2]
[1]
G DISASSEMBLY/REASSEMBLY > 5. bizhub C368/C308/C258
5. Remove six screws [1] from the PWB box side panel.
6. Remove three screws [1] from the PWB box front panel.
NOTE
▪ Note that only the size of the screw "A" is different.
7. Disconnect the connector [1].
8. Open the PWB box [2].
11. Remove the screw [1].
12. Remove the harness guide [2] as clearing the harness.
G-30