Konica Minolta bizhub C658 Service Manual page 616

bizhub C658/C558/C458/C368/C308/C258
[1]
[1]
[3] [2] [3] [2]
15. To reinstall, reverse the order of removal.
8.14.11 FS control board (FSCB) (FS-534/FS-534SD)
1. Remove the finisher from the main body.
G.8.14.6 Finisher (FS-534/FS-534SD)
2. Remove the rear cover.
G.8.14.1 Rear cover (FS-534/FS-534SD)
[1]
[2] [1]
5. To reinstall, reverse the order of removal.
8.14.12 FNS entry transport motor (M2) (FS-534/FS-534SD)
1. Remove the finisher from the main body.
G.8.14.6 Finisher (FS-534/FS-534SD)
2. Remove the rear cover.
G.8.14.1 Rear cover (FS-534/FS-534SD)
[3] [1]
[2]
13. Insert the rail [1] on the right side into the finisher.
14. Grip the portion as shown in the illustration [1] to raise the saddle unit and take
it out.
NOTE
▪ For installation of the saddle unit, insert two hooks on the left rail [3]
into the two holes of the saddle unit [2].
3. Remove all connectors from the board.
4. Remove four screws [1], and remove the FS control board [2].
3. Disconnect the connector [1].
4. Remove two screws [2], and remove the FNS entry transport motor assy [3].
G-316
G DISASSEMBLY/REASSEMBLY > 8. Option