Konica Minolta bizhub C658 Service Manual page 833

bizhub C658/C558/C458/C368/C308/C258
Function Name
IWS Settings
Report File Attachment
Storage data backup
CS Remote Care
Maintenance Mode
Access
Simple Connection
Setting
Administrator Password
Change Permission
Setting
USB Connection
Permission setting
2.11.14 Security Settings - HDD Encryption Setting
(1) Use
• To set the encrypting passphrase.
• To re-set encrypting passphrase due to exchange of SSD board or etc.
NOTE
▪ HDD formatting is required after this setting. Therefore it is necessary to retrieve certain data from HDD in advance.
The following data will be lost after HDD formatting.
1. Address data
2. Authentication data: Authentication mode, user authentication setting, account track setting
3. Box setting data: Box and text in the box, setting information of each box, box for fax
4. Job history, fax transmission history
And after setting the HDD encryption key, the movie data, voice data, OCR dictionary data, PDF/A font, OCR font, and Unicode
font need to be reinstalled as necessary since these data will be deleted by HDD format.
▪ If you replace the HDD due to its breakage or other reasons, you can automatically reset the encryption passphrase by
installing a new HDD and performing the logical format.
▪ Make sure to configure the following settings after formatting the HDD.
▪ Installing the firmware.
▪ Reinstall movie data, voice data, OCR dictionary data, and PDF/A fonts with the install data function under the service
mode.
[Service Mode] -> [System 2] -> [Install Data]
▪ Make sure to install the firmware after the format of the hard disk. Otherwise a trouble code " C-D012 mount error due to
unformatted HDD " will appear.
(2) Procedure
1. Press [HDD Encryption Setting].
2. Enter encryption passphrase (20 characters) with the keyboard on the operation panel and press [OK].
NOTE
▪ Double-byte and identical characters are not acceptable.
3. Turn OFF the main power switch and turn it ON again more than 10 seconds after.
4. Open [Administrator Settings] and conduct HDD formatting according to the instruction appeared on the panel.
5. Turn OFF the main power switch and turn it ON again more than 10 seconds after.
2.11.15 Security Settings - Debug Log Encryption Settings
(1) Debug Log Encryption Settings
Set the operating environment
of IWS (Internal Web Server)
function.
To set whether to convert a TX
result report to a file and attach
it to an E-mail.
To set whether to permit our
service representative to back
up or restore the storage on
this machine.
CS Remote Care enables the
machine and the computer at
CS Remote Care center to
exchange data through
telephone/fax line, network or
E-mail in order to control the
machine.
To set whether to permit your
service representative to
change [Administrator Settings]
of a device without
authentication.
To set the pairing method to
connect to an Android/iOS
device.
Specify whether to allow the
administrator password to be
changed via the IWS
application.
Specify whether to permit a
function that requires the USB
Port.
I ADJUSTMENT/SETTING > 2. List of utility mode
Default Setting When Enhanced Security mode is set to [ON]
OFF OFF (not to be changed)
With Attachment Without Attachment (not to be changed)
Restrict Restrict (not to be changed)
Usable Remote device setting disabled
Restrict Restrict (not to be changed)
• QR Code • OFF (not to be changed)
Display • OFF (not to be changed)
Setting: OFF • OFF (not to be changed)
• Enable NFC:
OFF
• Enable
Bluetooth LE:
OFF
Restrict Restrict (not to be changed)
Detail Setting Restrict (not to be changed)
I-63