Konica Minolta bizhub C658 Service Manual page 442

bizhub C658/C558/C458/C368/C308/C258
[2]
[1] [3]
12. To reinstall, reverse the order of removal.
6.5.7 Toner supply motor/C (M7) (bizhub C658/C558)
1. Remove the duct cover.
G.6.2.23 Duct cover/1
G.6.2.24 Duct cover/2, filter assy
2. Remove the toner filter.
F.8.1.1 Replacing the toner filter
3. Remove the lower rear cover.
G.6.2.21 Lower rear cover
4. Remove the scanner left cover.
G.6.2.4 Scanner left cover
5. Remove the scanner rear cover.
G.6.2.1 Scanner rear cover
6. Remove the DF cable cover.
G.6.2.22 DF cable cover
7. Remove the upper rear cover.
G.6.2.25 Upper rear cover
8. Remove the paper cooling fan assy.
G.6.7.7 Paper cooling fan (FM8)
9. Remove the board box/2.
G.6.3.10 PWB box/2 (bizhub C658/C558)
[2]
[1] [3]
11. To reinstall, reverse the order of removal.
6.5.8 Toner supply motor/C (M7) (bizhub C458)
1. Remove the duct cover.
G.6.2.23 Duct cover/1
G.6.2.24 Duct cover/2, filter assy
2. Remove the toner filter.
F.8.1.1 Replacing the toner filter
3. Remove the lower rear cover.
G.6.2.21 Lower rear cover
4. Remove the scanner left cover.
G.6.2.4 Scanner left cover
5. Remove the scanner rear cover.
G.6.2.1 Scanner rear cover
6. Remove the DF cable cover.
G.6.2.22 DF cable cover
7. Remove the upper rear cover.
G.6.2.25 Upper rear cover
8. Remove the paper cooling fan assy.
G.6.7.7 Paper cooling fan (FM8)
9. Remove the toner cartridge cooling fan assy.
G.6.7.5 Toner cartridge cooling fan (FM4) (bizhub C458)
G DISASSEMBLY/REASSEMBLY > 6. bizhub C658/C558/C458
11. Remove the screw [1]. Disconnect the connector [2] and then remove the toner
supply motor/K [3].
10. Remove the screw [1]. Disconnect the connector [2], and remove the toner
supply motor/C [3].
NOTE
▪ When removing the toner supply motor/C [3], make sure to turn it in
the direction shown in the illustration.
G-142