Konica Minolta bizhub C658 Service Manual page 845

bizhub C658/C558/C458/C368/C308/C258
Print Head Skew Adj.
LD adjustment
Manual Bypass Tray Width Adj
Lead Edge Erase Adjustment
Non-Image Area Erase Check
ADF Scan Glass Contamination
PPM Control Choice
High Humidity PPM Adjustment *3
Exhaust Fan Stop Delay
Move Scanner to Home
*1: It is not used on bizhub C368/C308/C258.
*2: It is not used on bizhub C658/C558.
*3: It is not used on bizhub C458/C368/C308/C258.
4.2.2 Imaging Process Adjustment
NOTE
▪ After exiting Service Mode, you must turn OFF the main power switch. Turning ON the main power switch again after waiting 10
seconds makes the changes to the Service Mode setting take effect.
Imaging Process Adjustment
Gradation Adjust
Stabilizer
Machine
Print Head Skew Adj.
Print Head Skew Reset
LD Timing Adj. *3
LD 1/2 Balance Adj. *3
LD Light Width Adjustment
Initialize + Image stabilization
I ADJUSTMENT/SETTING > 4. LIST OF SERVICE MODE
I.5.4.9 (1) Print Head Skew Adj.
I.5.4.9 (2) Print Head Skew Reset
I.5.4.10 (1) LD Timing Adj.
I.5.4.10 (2) LD 1/2 Balance Adj.
I.5.4.10 (3) LD Light Width Adjustment
I.5.4.11 Manual Bypass Tray Width Adj
I.5.4.12 Lead Edge Erase Adjustment
I.5.4.13 Non-Image Area Erase Check
I.5.4.14 ADF Scan Glass Contamination
I.5.4.15 PPM Control Choice
I.5.4.16 High Humidity PPM Adjustment
Not used
I.5.4.17 Move Scanner to Home
I.5.6.1 Gradation Adjust
I.5.6.2 Stabilizer
I-75
Ref. Page
Ref. Page