Konica Minolta bizhub C658 Service Manual page 312

bizhub C658/C558/C458/C368/C308/C258
[2]
[1]
[3]
[3] [2]
[1]
[5]
[4]
[2]
[1] [1]
[2] [1]
G DISASSEMBLY/REASSEMBLY > 5. bizhub C368/C308/C258
8. Remove two cable ties [1] from the control panel.
9. Remove the cable from the cable guide [2].
NOTE
▪ At installation of the control panel unit, insert the cable tie [1] to the
hole [3] shown in the illustration.
10. Remove the harness from the wire saddle [1].
11. Remove two screws [2], and remove the metal plate [3].
NOTE
▪ When installing the control panel, install the shaft [4] into the hole [5]
in the figure.
12. Remove three screws [1], and remove the control panel unit [2].
13. Unhook the claw [1], and remove the hinge cover [2].
G-12