Konica Minolta bizhub C658 Service Manual page 989

bizhub C658/C558/C458/C368/C308/C258
(i) V27ter: Setting item
• 4800bps
• 2400bps
(j) V21
• No parameters
(k) PB: Default setting
• 0
(l) PB: Setting item
• 0 to 9, *, #, A, B, C, D
(m) DP: Default setting
• 0
(n) DP: Setting range
• 0 to 9
(o) Special Tone: Default setting
• 1100Hz
(p) Special Tone: Setting item
• 1100Hz
• 1300Hz
• 1650Hz
• 2100Hz
(q) Optional Tone: Default setting
• 200Hz
(r) Optional Tone: Setting range
• 200 to 4000Hz (step: 100Hz)
(s) PB Tone (High): Default setting
• 1209Hz
(t) PB Tone (High): Setting item
• 1209Hz
• 1336Hz
• 1477Hz
• 1633Hz
(u) PB Tone (Low): Default setting
• 697Hz
(v) PB Tone (Low): Setting item
• 697Hz
• 770Hz
• 852Hz
• 941Hz
(w) Pseudo Ring
• No parameters
5.20.11 Fax Test-Signal Receive Test
• It will be displayed only when optional FAX kit FK-514 is mounted.
• Specifiable for each line when there are multiple fax lines
(1) Use
• Check a signaling tone by connecting the machine to the line to output a test signal of the fax board.
• Signal sounds are monitored by the monitor speaker.
(2) Procedure
1. Call the Service Mode to the screen.
2. Select -> [Test Mode] -> [FAX Test] -> [Fax Line Test].
3. Select a line, and touch the [Signal Receive Test].
4. Select a test item.
5. Select the parameter you would like to test.
6. Press the [Start] key. (In order to move to another test, select the next test item after pressing the [Stop] key.)
I ADJUSTMENT/SETTING > 5. SERVICE MODE
I-219