Konica Minolta bizhub C658 Service Manual page 924

Hide thumbs Also See for bizhub C658:

Table of Contents

bizhub C658/C558/C458/C368/C308/C258

(3) Setting item

1. Do Not Use

5.16.11 Line Mag Setting

• To set whether to use the offset value which has been set prior to the shipping. To display the current magnification offset value.

• When CCD board (front side)/CIS (back side: only when dual scan document feeder is mounted) has been replaced, set to "OFF."

After replacing the CCD board or CIS, the default generic value needs to be set since the magnification offset value between the lines set

for each unit changes to control the differences in reading performance on each scanner (CCD).

• The original offset value can be disabled to address image failure and other problems caused by individual CCD performance difference.

• When dual scan document feeder is mounted, this setting can be made separately for [Front Side] and [Back Side].

(2) Default setting

(3) Setting item

▪ When the setting is changed, the function becomes valid by turning the main power switch OFF and ON again.

5.16.12 Data Capture

• When an error occurs, it acquires the print job data in order to analyze the cause of the error.

• When an error occurs, this will be used to analyze the cause of the error according to the print job data.

(2) Procedure

The following conditions are necessary for this function.

• [Allow] must be set when selecting [Administrator Settings] [Security Setting] -> [Security Details] -> [Print Data Capture].

• The hard disk must be mounted to the machine.

• [ON] must be set when selecting [Administrator Settings] -> [Network Settings] -> [FTP Settings] -> [FTP Server Settings].

• This function also allows print job data stored in the HDD to be obtained from [Debug Settings] -> [Debug Log Output].

1. Select [Service Mode] -> [System 2], and touch [Data Capture]. Select [ON].

(While the Data Capture setting is [ON], the print job data from the PC will be stored in the hard disk.)

▪ Maximum 5 print job data can be stored. The data will be overwritten beginning with the chronologically oldest one.

2. Check the IP address of the machine.

3. Connect the PC (Windows) and the machine with ethernet cable.

4. Start the DOS command prompt of the PC, and specify the IP address of the machine to start FTP.

5. Input the user name and the password.

• User name: capture

• Password: sysadm

6. Using the "ls" command, display the list of the file available for capture.

I ADJUSTMENT/SETTING > 5. SERVICE MODE

Show Quick Links

Table of Contents