Konica Minolta bizhub C658 Service Manual page 899

bizhub C658/C558/C458/C368/C308/C258
• Fax is available only when the optional fax kit is being installed.
5.14.2 Maintenance/Default Settings - ID Code
(1) Use
• To register the service ID.
(2) Procedure
1. Touch [ID code] and enter the service ID.
• Enter a 7-digit code from the 10-key pad. (0000001 to 9999999)
2. Touch [ID code] to register the ID.
3. The [Detail Setting] will appear when the ID has been registered.
5.14.3 Maintenance/Default Settings - Detail Setting
(1) Basic Setting (E-Mail1, E-Mail2, Modem or Fax)
(a) Use
• Execute the primary setting.
• Use to register the machine to the CS Remote Care center.
(b) Procedure
1. Call the Service Mode to the screen.
2. Touch [CS Remote Care] -> [Maintenance/Default Settings].
3. Touching the [Detail Setting] will display the primary setting.
<Center Setting>
• Set the center ID, Device ID, and the phone No.
• When e-mail is selected for system and all setup procedures are completed, e-mail address of the center is displayed.
NOTE
▪ When entering the phone number, 10-key and keys on the screen have following meanings.
[-] Pose
[W] Wait
[T] Tone dial
[P] Pulse dial
[*], [#]
<Schedule (Only when the [E-Mail2] is selected)>
• Set the schedule of notification to the center.
• Up to three different notification schedules can be registered.
• Select the notification cycle from [Day], [Week], or [Month].
When selecting [Day] for the notification cycle, set the Day Frequency.
When selecting [Week] for the notification cycle, set the Week Frequency and day of the week.
When selecting [Month], set the Month Frequency and the date of the month.
<Center Notification (Only when the [E-Mail2] is selected)>
• Select the items of data that will be sent to the center in one-way transmission through E-Mail2.
• The following table shows each of the notification item keys and corresponding data.
[1] Sales count data
[2] Error count data
[3] Service count data
[4] Life count data
Life cycle data
[5] CSRC-System data
Device config data
[6] History data
NOTE
▪ Multiple items of data can be selected and sent at one time. However, be sure that only EKC data cannot be sent together
with other items of data.
<Initial Transmission>
• Touching the Initial Transmission key will sent the information to the CS Remote Care center to register the machine. (Only when the
modem or fax is selected on the system Input.)
(2) Basic Setting (http1 or http2)
(a) Use
• Execute the primary setting.
• Use to register the machine to the CS Remote Care center.
(b) Procedure
1. Call the Service Mode to the screen.
2. Touch [CS Remote Care] -> [Maintenance/Default Settings].
3. Touching the [Detail Setting] will display the primary setting.
<Center Setting>
• Set the center ID.
• Display the device ID.
Waits to start transmitting after dialing
Detects the dial tone of the other end
Carry out tone dialing
Carry out pulse dialing
To be used as necessary
I-129
I ADJUSTMENT/SETTING > 5. SERVICE MODE
[7] EKC data
[8] Adjustment data
[9] Coverage data
[10] Not used
[11] Not used
[12] Not used