Konica Minolta bizhub C658 Service Manual page 328

bizhub C658/C558/C458/C368/C308/C258
[1] [2]
[3]
[2] [3]
[1]
11. To reinstall, reverse the order of removal.
12. Select [Service Mode] -> [State Confirmation] -> [Memory/Storage Adjustment] -> [Format], and conduct the HDD format function.
13. [Service Mode] -> [State Confirmation] -> [Memory/Storage Adjustment] ->
5.3.9 Hard disk (A) Cover type
1. Remove the lower rear cover.
G.5.2.20 Lower rear cover
[3]
[1] [4]
[1] [2] [1]
[1] [1]
[1]
[2]
[2]
G DISASSEMBLY/REASSEMBLY > 5. bizhub C368/C308/C258
8. Remove four screws [1].
9. Remove the plate spring [2], and remove the plate [3].
10. Remove four metal plates [2] and two connectors [3] from the hard disk [1].
[Storage R/W
2. Remove the harness from the wire saddle [1].
3. Remove the harness from the edge cover [2].
4. Disconnect two connectors [3].
NOTE
▪ When the ferrite core [4] has been installed, be sure to install the
hard disk at the position shown in the illustration.
▪ Ensure that the cables do not contact with the MFP board at
connecting the connectors [3].
▪ When the security kit SC-508 has been installed, ensure that the
cables do not contact with the DSC board at connecting the
connectors [3].
5. Remove four screws [1], and remove the hard disk assy [2].
G-28
Check]