Konica Minolta bizhub C658 Service Manual page 487

bizhub C658/C558/C458/C368/C308/C258
6. NOTE
• Be sure to perform the following steps after the multi feed detection board/2 (receiver) has been replaced with a new one.
• Execute [Service Mode] -> [ADF] ->
7.2.16 Take-up motor (M1) (dual scan document feeder)
1. Remove the rear cover.
G.7.2.2 Rear cover (dual scan document feeder)
[2]
[3]
[1]
[1]
[2]
[5] [2] [3] [1]
[4]
5. NOTE
[1]
[2]
[Multi-Feed DetectionAdj]
2. Remove the screw, and disconnect the ground wire [1].
[1]
3. Remove six wire saddles [2] and disconnect six connectors [3].
4. Remove two screws [1].
5. Unhook two hooks [1], remove the harness from the harness guide [2], and
6. Remove the screw [1], E-ring [2], and bushing [3].
7. Remove three screws [4] and remove the take-up motor assy [5].
G DISASSEMBLY/REASSEMBLY > 7. Dual scan document feeder
▪ Install the board so that the sensor [1] fits into the depression [2].
.
remove the harness guide [2].
G-187