Konica Minolta bizhub C658 Service Manual page 483

bizhub C658/C558/C458/C368/C308/C258
[1]
[2]
[1]
[1]
[1]
[2]
[1]
7. To reinstall, reverse the order of removal.
NOTE
▪ Be sure to perform the following steps after the CIS module has been replaced with a new one.
▪ Adjust the back side skew feed on the dual scan document feeder.
I.13.1.3 Adjusting back side skew feed on dual scan document feeder
▪ Execute [Service Mode] -> [System 2] ->
▪ Execute [Service Mode] -> [System 2] ->
▪ Execute [Service Mode] -> [ADF] ->
▪ Execute [Service Mode] -> [ADF] ->
▪ Execute [Service Mode] -> [ADF] ->
2. Remove the screw [1], and disconnect two connectors [1].
3. Remove two screws (front side) [1].
4. Remove the screw (rear side) [1].
5. Remove the CIS module [1] as shown in the illustration.
6. Remove the E-rings [1] on the right and left, and remove the plates [2].
[CCD Calibration] .
[Line Mag Setting] .
[Auto Stop Position Adjustment] .
[FD-Mag. Adj. (B)] .
[Main Scanning Direction Zoom] .
G-183
G DISASSEMBLY/REASSEMBLY > 7. Dual scan document feeder