Konica Minolta bizhub C658 Service Manual page 447

bizhub C658/C558/C458/C368/C308/C258
G.6.2.23 Duct cover/1
G.6.2.24 Duct cover/2, filter assy
2. Remove the toner filter.
F.8.1.1 Replacing the toner filter
3. Remove the lower rear cover.
G.6.2.21 Lower rear cover
4. Remove the scanner left cover.
G.6.2.4 Scanner left cover
5. Remove the scanner rear cover.
G.6.2.1 Scanner rear cover
6. Remove the DF cable cover.
G.6.2.22 DF cable cover
7. Remove the upper rear cover.
G.6.2.25 Upper rear cover
8. Remove the paper cooling fan assy.
G.6.7.7 Paper cooling fan (FM8)
[1] [3]
11. To reinstall, reverse the order of removal.
6.5.16 Tray 1 lift-up motor (M12)
1. Remove the duct cover.
G.6.2.23 Duct cover/1
G.6.2.24 Duct cover/2, filter assy
2. Remove the toner filter.
F.8.1.1 Replacing the toner filter
3. Remove the lower rear cover.
G.6.2.21 Lower rear cover
4. Remove the protective shield.
G.6.2.26 Protective shield
5. Open the PWB box.
G.6.3.9 How to open the PWB box/1
6. Remove the high voltage unit.
G.6.4.11 High voltage unit (HV)
7. Slide out the tray 1.
[3] [2]
[1]
9. To reinstall, reverse the order of removal.
6.5.17 Tray 2 lift-up motor (M13)
1. Remove the duct cover.
G.6.2.23 Duct cover/1
G.6.2.24 Duct cover/2, filter assy
2. Remove the toner filter.
F.8.1.1 Replacing the toner filter
3. Remove the lower rear cover.
G.6.2.21 Lower rear cover
4. Remove the protective shield.
G.6.2.26 Protective shield
5. Open the PWB box.
G.6.3.9 How to open the PWB box/1
6. Remove the high voltage unit.
G.6.4.11 High voltage unit (HV)
7. Slide out the tray 2.
[2]
G DISASSEMBLY/REASSEMBLY > 6. bizhub C658/C558/C458
9. Disconnect the connector [1], and remove the harness from the harness guide.
10. Remove two screws [2], and remove the fusing pressure motor [3].
8. Remove three screws [1]. Disconnect the connector [2], and remove the tray 1
lift-up motor [3].
G-147