Konica Minolta bizhub C658 Service Manual page 486

bizhub C658/C558/C458/C368/C308/C258
[2] [4]
[1] [3]
4. To reinstall, reverse the order of removal.
[1]
[2]
6. NOTE
• Be sure to perform the following steps after the multi feed detection board/1 (transmitter) has been replaced with a new one.
• Execute [Service Mode] -> [ADF] ->
7.2.15 Multi feed detection board/2 (receiver) (MFDB/2)
[1]
[2] [1]
[1] [2]
4. To reinstall, reverse the order of removal.
2. Remove two screws [1], and disconnect the ground wire [2].
3. Disconnect the connector [3] and remove the multi feed detection board/1 [4].
5. NOTE
▪ Install the board so that the sensor [1] fits into the depression [2].
[Multi-Feed DetectionAdj] .
1. Remove the cover from the dual scan document feeder [1].
2. Remove the screw [1] and pull out the multi feed detection board/2 [2].
3. Disconnect the connector [1] and remove the multi feed detection board/2 [2].
G-186
G DISASSEMBLY/REASSEMBLY > 7. Dual scan document feeder