Konica Minolta bizhub C658 Service Manual page 710

bizhub C658/C558/C458/C368/C308/C258
G.8.19.12 Finisher (FS-537/FS-537SD)
2. Remove the rear cover of the finisher.
Rear cover (FS-537/FS-537SD)
[2] [4] [1] [3]
[3] [1] [3]
5. Reinstall the above parts following the removal steps in reverse.
8.22.3 ZU relay board (ZURB) (ZU-609)
1. Remove the finisher sub tray (paper exit upper tray).
G.8.19.9 Sub tray (Paper exit upper tray) (FS-537/FS-537SD)
[2] [1]
[2] [3]
[1]
5. Reinstall the above parts following the removal steps in reverse.
8.22.4 ZU transport motor (M500) (ZU-609)
1. Remove the finisher from the main body.
G.8.19.12 Finisher (FS-537/FS-537SD)
2. Remove the rear cover of the finisher.
Rear cover (FS-537/FS-537SD)
[2]
[2] [3] [2]
5. Reinstall the above parts following the removal steps in reverse.
8.22.5 Folding guide motor (M501) (ZU-609)
1. Remove the Z folding unit.
Z Folding Unit (ZU-609)
[1]
[1]
3. Disconnect five connectors [1] on the ZU drive board.
4. Remove the screw [2] and three board supports [3], then remove the ZU drive
board [4].
2. Remove the screw [1], and remove the cover [2].
3. Disconnect two connectors [1] on the ZU relay board.
4. Remove two screws [2], and remove the ZU relay board [3].
3. Disconnect the connector [1].
4. Remove four screws [2] and remove the ZU transport motor [3].
G-410
G DISASSEMBLY/REASSEMBLY > 8. Option