Konica Minolta bizhub C658 Service Manual page 389

bizhub C658/C558/C458/C368/C308/C258
[2]
[1]
[2]
[1]
[3]
[1]
[1] [2]
[3]
[4]
[1]
G DISASSEMBLY/REASSEMBLY > 6. bizhub C658/C558/C458
5. Release the tab [1], and remove the control panel connector cover [2].
6. Disconnect the connector [1].
7. Remove the tie band [1] from the control panel.
8. Remove the cable from the cable guide [2].
NOTE
▪ At installation of the control panel unit, insert the cable tie [1] to the
hole [3] shown in the illustration.
9. Remove two screws [1].
10. Remove the screw [1], and remove the operation panel unit [2].
NOTE
▪ When installing the control panel, install the metal panel shaft [3]
into the hole [4] in the figure.
G-89