Konica Minolta bizhub C658 Service Manual page 926

bizhub C658/C558/C458/C368/C308/C258
NOTE
▪ Be aware that selecting "Not Set" and performing the pre-detection with [Service Mode] -> [Machine] -> [ADF Scan Glass
Contamination] will display "NG."
▪ When "Not Set" is selected, the original glass cleaning operation after the job ends does not operate.
(b) Default setting
• Normal
(c) Setting item
• Not Set
• Low
• Normal
• High
(2) ADF Scan Glass Contamin. Warn/Level
(a) Use
• To set how to display the warning when stain on the DF original glass (or the CIS glass) is detected.
• Use when changing the display of the warning which requests the cleaning of the stain on the glass detected by the pre-detection of
the lines.
0
1
2
3
NOTE
▪ This setting is invalid when [ADF Scan Glass Contamin. Sensitivity] is set to "Not Set."
(b) Default setting
• 1
(c) Setting item
• 0
• 1
• 2
• 3
(3) Feed Cleaning Settings
(a) Use
• To set the operation for detection and cleaning operation of stain on the DF original glass when feeding the original.
• Use when changing the operation for detection and cleaning operation of stain on the DF original glass when feeding the original.
0
1
(b) Default setting
• 1
(c) Setting item
• 0
• 1
(4) Display Timing (only when dual scan document feeder is mounted)
(a) Use
• To set the timing at which a warning is displayed when contamination is detected on the surface of the CIS glass in a pre-detection
process.
Back Scan Time
Warning Detection
• This setting is enabled only when [Back Side] is selected.
(b) Default setting
• During the Back Side Scan
(c) Functions
• Warning Detection
• During the Back Side Scan
Warning will not be displayed.
Warning will be displayed by the maintenance mark. (Malfunction code: D-1/D-3)
Warning will be displayed on the message area on the basic screen.
Warning will be displayed on all screens.
The cleaning brush will stop moving when the original is fed, and will not perform cleaning the
stain.
The cleaning brush will move between originals when feeding the original.
Displays the warning only when back side scanning mode is selected.
Displays the warning whenever contamination is detected.
I-156
I ADJUSTMENT/SETTING > 5. SERVICE MODE