Konica Minolta bizhub C658 Service Manual page 908

bizhub C658/C558/C458/C368/C308/C258
• Prohibit
5.15.5 Foolscap Size Setting
(1) Use
• To set the size for foolscap paper.
• Upon setup.
(2) Procedure
• Select the size from among the following six.
(3) Default setting
• 8 x 13
(4) Functions
1 1
• 8 / x 13 /
2 2
• 220 x 330 mm
1
• 8 / x 13
2
1
• 8 / x 13
4
1 1
• 8 / x 13 /
8 4
• 8 x 13
NOTE
1 1
▪ "8 / x 13 / " and "220 x 330 mm" setting are corresponding to paper fed from the manual bypass tray only.
8 4
5.15.6 Original Size Detection
(1) Copy Glass
(a) Use
• To change the size detection table for the document glass.
(b) Default setting
• Table1
(c) Setting item
• Table1
• Table2
NOTE
▪ Table 2 can be set only when original size sensor 2 is being mounted. (For destinations other than Japan)
▪ On models for Japan, original size sensor 2 is not required, but Table 2 can be set.
(2) 8-1/2 x 14/Foolscap Size Detection
(a) Use
• To set whether paper of 8
When Table 1 is selected in Copy Glass, paper of 81/2 x 131/2 size is detected as Foolscap despite of the setting of 8
Size Detection.
• Not available for Japan models.
(b) Default setting
1
• 8 / x14
2
(c) Functions
1
• 8 / x14
2
• Foolscap
(3) ADF Size Detection
(a) Use
• To set whether or not to give a priority to the detection of 8K/16K size when DF is used.
• Not available for Japan models.
(b) Default setting
• K Size
(c) Functions
• K Size
• B series
5.15.7 Install Date
(1) Use
• To register the date the main body was installed.
• Upon setup.
1 1
/ x 13 / size is detected as 8
2 2
1
/ x 14 or foolscap in original glass or DF size detection.
2
I-138
I ADJUSTMENT/SETTING > 5. SERVICE MODE
1
/ x 14/Foolscap
2