Konica Minolta bizhub C658 Service Manual page 221

bizhub C658/C558/C458/C368/C308/C258
(3) Reinstall procedure
[1]
3. Close the front door.
7.6.2 Cleaning of the area around the waste toner collecting port
(1) Periodically cleaning parts/cycle
• Area around the waste toner collecting port: Every 60,000 counts (upon each call)
(2) Procedure
1. Remove the waste toner box.
F.7.6.1 Replacing the waste toner box
7.7 Paper feed section
7.7.1 Replacing the tray 1 feed roller, tray 1 pick-up roller, tray 1 separation roller
(1) Periodically replacing parts/cycle
• Tray 1 feed roller: Every 300,000 counts
• Tray 1 pick-up roller: Every 300,000 counts
• Tray 1 separation roller: Every 300,000 counts
(2) Procedure
1. Open the right door.
2. Remove the tray 1.
G.5.2.23 Tray 1
3. Remove the tray 2.
G.5.2.24 Tray 2
[3]
[1] [2]
5. To reinstall, reverse the order of removal.
6. Select [Service Mode] -> [Counter] -> [Life] and clear the count of [1st.].
7.7.2 Replacing the tray 2 feed roller, tray 2 pick-up roller, tray 2 separation roller
(1) Periodically replacing parts/cycle
• Tray 2 feed roller: Every 300,000 counts
• Tray 2 pick-up roller: Every 300,000 counts
• Tray 2 separation roller: Every 300,000 counts
(2) Procedure
1. Open the right door.
2. Remove the tray 1.
G.5.2.23 Tray 1
F PERIODICAL MAINTENANCE > 7. Periodical maintenance procedure bizhub C368/
[1]
[4]
1. Remove the brand new waste toner box from its package and remove the
packing material.
2. Set the waste toner box [1].
2. Wipe the areas around the waste toner collecting port clean of spilled toner
and dirt using a cleaning pad with water or alcohol.
4. Remove the C-clip [1] each, and remove the tray 1 feed roller [2], tray 1 pick-
up roller [3] and tray 1 separation roller [4].
F-33
C308/C258