Konica Minolta bizhub C658 Service Manual page 234

bizhub C658/C558/C458/C368/C308/C258
[1]
3. Close the lower front door.
8.7.2 Cleaning of the area around the waste toner collecting port
(1) Periodically cleaning parts/cycle
• Area around the waste toner collecting port: Every 60,000 counts (upon each call)
(2) Procedure
1. Remove the waste toner box.
F.8.7.1 Replacing the waste toner box
8.8 Document feed section
8.8.1 Replacing the tray 1 feed roller, tray 1 pick-up roller, tray 1 separation roller
(1) Periodically replacing parts/cycle
• Tray 1 feed roller: Every 300,000 counts
• Tray 1 pick-up roller: Every 300,000 counts
• Tray 1 separation roller: Every 300,000 counts
(2) Procedure
1. Open the right door.
2. Remove the tray 1.
G.6.2.27 Tray 1
3. Remove the tray 2.
G.6.2.28 Tray 2
[1]
[3] [2] [4]
7. To reinstall, reverse the order of removal.
8. Select [Service Mode] -> [Counter] -> [Life] and clear the count of [1st.].
8.8.2 Replacing the tray 2 feed roller, tray 2 pick-up roller, tray 2 separation roller
(1) Periodically replacing parts/cycle
• Tray 2 feed roller: Every 300,000 counts
• Tray 2 pick-up roller: Every 300,000 counts
• Tray 2 separation roller: Every 300,000 counts
F PERIODICAL MAINTENANCE > 8. Periodical maintenance procedure bizhub C658/
1. Remove the brand new waste toner box from its package and remove the
packing material.
2. Set the waste toner box [1].
2. Wipe the areas around the waste toner collecting port clean of spilled toner
and dirt using a cleaning pad with water or alcohol.
4. Release the tab [1], and remove the tray 1 feed roller [2].
5. Release the tab [1], and remove the tray 1 pick-up roller [3].
6. Release the tab [1], and remove the tray 1 separation roller [4].
F-46
C558/C458