Konica Minolta bizhub C658 Service Manual page 358

bizhub C658/C558/C458/C368/C308/C258
G.5.2.20 Lower rear cover
2. How to open the PWB box
G.5.3.10 How to open the PWB box
3. Remove the high voltage unit.
G.5.4.8 High voltage unit (HV)
4. Slide out the tray 1.
[3] [2] [1]
[1]
6. To reinstall, reverse the order of removal.
5.5.13 Tray 2 lift-up motor (M13)
1. Remove the lower rear cover.
G.5.2.20 Lower rear cover
2. How to open the PWB box
G.5.3.10 How to open the PWB box
3. Remove the high voltage unit.
G.5.4.8 High voltage unit (HV)
4. Slide out the tray 2.
[2]
[1] [3] [1]
6. To reinstall, reverse the order of removal.
5.5.14 Developing motor (M21)
1. Remove the lower rear cover.
G.5.2.20 Lower rear cover
2. Open the PWB box.
G.5.3.10 How to open the PWB box
[3] [1]
[2] [1]
4. To reinstall, reverse the order of removal.
NOTE
▪ When installing the motor, use care not to mistake in the kind of the mounting screws (M3x6mm).
5.5.15 Toner cartridge motor/K (M25)
1. Remove the lower rear cover.
G.5.2.20 Lower rear cover
2. Remove the scanner rear cover.
G.5.2.1 Scanner rear cover
3. Remove the upper rear cover.
G.5.2.22 Upper rear cover
G DISASSEMBLY/REASSEMBLY > 5. bizhub C368/C308/C258
5. Remove three screws [1]. Disconnect the connector [2], and remove the tray 1
lift-up motor [3].
5. Remove three screws [1]. Disconnect the connector [2], and remove the tray 2
lift-up motor [3].
3. Remove four screws [1]. Disconnect the connector [2], and remove the
developing motor [3].
G-58