Konica Minolta bizhub C658 Service Manual page 695

bizhub C658/C558/C458/C368/C308/C258
[1]
[1]
[2]
17. To reinstall, reverse the order of removal.
8.20.5 SD control board (SDCB) (FS-537SD saddle section)
1. Remove the saddle unit.
Saddle unit (FS-537SD saddle section)
[3]
[2]
[3] [4] [2]
[1]
A
8. To reinstall, reverse the order of removal.
NOTE
▪ After replacing the SD control board, be sure to install the latest firmware.
15. Disconnect the connector [1].
16. Remove two screws [1], and remove the staple unit [2].
[1]
A
2. Remove two screws [1].
3. Remove the board support film [3] from the harness guide [2].
4. Disconnect all connectors on the SD control board.
5. Remove four screws [1].
6. Remove the SD control board [3] from the 2 tabs [2].
NOTE
▪ Remount the EEPROM (U3) [4] when the SD control board (SDCB) is
replaced.
Install the EEPROM (U3) [4] from the old SD control board on to the
new SD control board.
7. NOTE
▪ When mounting EEPROM (U3), align the notches (indicated by "A" in
the illustration).
G-395
G DISASSEMBLY/REASSEMBLY > 8. Option