Konica Minolta bizhub C658 Service Manual page 673

bizhub C658/C558/C458/C368/C308/C258
[5] [3] [4]
[1]
[2]
[1] [3]
[2]
9. Reinstall the above parts following the removal steps in reverse.
8.19.18 Route change gate motor (M4) (FS-537/FS-537SD)
1. Remove the rear cover.
Rear cover (FS-537/FS-537SD)
[1] [1]
[1] [1]
[3] [2] [2]
[2] [4]
[6] [5]
[2]
[2]
[3]
5. Disconnect the connector [1].
6. Remove two screws [2], the E-ring [3], and the bushing [4], and remove the
Pre-eject drive motor [5].
7. Disconnect the connector [1].
8. Remove two screws [2] and remove the stacker plate drive motor [3].
2. Remove the harness from 12 wire saddles [1].
3. Disconnect five connectors [2].
4. Remove two screws [3] and remove the route change gate motor assy [4].
NOTE
▪ During installation, you must pass the metal plate [5] between the
belt [6].
G-373
G DISASSEMBLY/REASSEMBLY > 8. Option