Konica Minolta bizhub C658 Service Manual page 353

bizhub C658/C558/C458/C368/C308/C258
[1]
[1] [2]
7. To reinstall, reverse the order of removal.
NOTE
▪ When installing the motor, use care not to mistake in the kind of the mounting screws (M3x6mm).
5.5.4 Switchback motor (M4)
(1) Removal procedure
1. Remove the lower rear cover.
G.5.2.20 Lower rear cover
2. Remove the scanner rear cover.
G.5.2.1 Scanner rear cover
3. Remove the upper rear cover.
G.5.2.22 Upper rear cover
4. Remove the rear right cover.
G.5.2.18 Rear right cover
[1]
[2] [1]
[2]
[2] [1]
[2]
[1]
[3]
G DISASSEMBLY/REASSEMBLY > 5. bizhub C368/C308/C258
6. Remove four screws [1]. Disconnect the connector [2], and remove the fusing
motor [3].
5. Remove four screws [1], and remove the paper cooling fan assy [2].
6. Remove the screw [1], and remove two tabs [2].
7. Remove the harness from the wire saddle [1].
8. Remove the harness guide [2] as clearing the harness.
G-53