Konica Minolta bizhub C658 Service Manual page 826

bizhub C658/C558/C458/C368/C308/C258
Accessing the machine directly
2.11.7 Network Settings - Remote Panel Settings (Server Settings)
(1) Use
• To access this machine directly and control the control panel of the machine remotely, select [ON].
(2) Default setting
• OFF
(3) Setting item
• ON
• OFF
(4) Procedure
• If [ON] is selected, configure the following settings.
(a) <Server Settings - Password Authentication>
• Select whether to request password entry for connecting with this machine. To request for a password entry, select [Yes], and enter
the password (using up to 64 characters).
(b) <Server Settings - IP Filtering (Permit Access)>
• Select [Enable] to specify IP addresses allowed to access. Also enter the range of IP addresses allowed to access.
(c) <Port Number>
• To set the port number.
NOTE
Starting the remote operations
Access the machine web server (URL: https://IP_address_of_MFP:Port_Number/panel/top.html) through the web browser.
• If Password Authentication is set, enter the set password.
• If IP Filtering is enabled, connection can be established only through the authorized address.
2.11.8 Network Settings - Remote Panel Settings (Client Settings)
(1) Use
• To control the control panel of this machine remotely using the dedicated software, select [ON].
(2) Default setting
• OFF
(3) Setting item
• ON
• OFF
(4) Procedure
• If [ON] is selected, configure the following settings.
(a) <Port No.>
• To set the port number.
(b) <Connection Timeout>
• To set the time-out time. (60 Second is specified by default)
(c) <Server Address>
• Enter the address of the server where the dedicated software was installed.
(d) <Certificate Verification Level Settings>
• To verify the server certificate, configure settings to verify the certificate.
Expiration Date
Key Usage
Chain
Expiration Date Confirmation
CN
• This method accesses this machine directly from another computer on the network, and
operates the control panel of the machine using a Web browser.
• A dedicated remote control software program is not required, but the computer used for the
remote control must be able to access this machine.
Select whether to check that the server certificate is within the validity period.
Select whether to check that the server certificate is used according to the purpose approved by
the issuer.
Select whether to check that the server certificate chain (certification path) is correct.
Select whether to check that the server certificate is within the validity period. The OCSP service
and CRL (Certificate Revocation List) are checked in this order when the expiration date of the
certificate is checked.
Select whether to check that the CN of the server certificate matches the server address.
I-56
I ADJUSTMENT/SETTING > 2. List of utility mode