Konica Minolta bizhub C658 Service Manual page 672

bizhub C658/C558/C458/C368/C308/C258
[4]
[1] [2] [3] [1]
[2] [1]
[1] [1]
19. Reinstall the above parts following the removal steps in reverse.
8.19.16 FS control board (FSCB) (FS-537/FS-537SD)
1. Remove the rear cover.
Rear cover (FS-537/FS-537SD)
[1]
[2] [1]
4. Reinstall the above parts following the removal steps in reverse.
8.19.17 Bundle eject motor (M1) / Pre-eject drive motor (M2) / Stacker plate drive motor (M3) (FS-537/FS-537SD)
1. Remove the left upper cover.
Left upper cover (FS-537/FS-537SD)
2. Remove the main tray (paper exit lower tray).
G.8.19.8 Main tray (Paper exit lower tray) (FS-537/FS-537SD)
[5] [1] [2]
[3]
[4]
16. Disconnect two connectors [1] and remove the harness from the wire saddle [2]
17. Remove the stapler assy [4].
18. Remove four screws [1], and remove the stapler unit [2].
[1]
2. Disconnect all connectors on the FS control board.
3. Remove four screws [1], and remove the FS control board [2].
3. Disconnect the connector [1], and remove the harness from the edge cover [2]
4. Remove two screws [4], and remove the bundle eject motor [5].
and harness guide [3].
and the wire saddle [3].
G-372
G DISASSEMBLY/REASSEMBLY > 8. Option