Konica Minolta bizhub C658 Service Manual page 363

bizhub C658/C558/C458/C368/C308/C258
[1]
[2]
[2]
[1]
[1]
[2]
5. To reinstall, reverse the order of removal.
5.6.4 Registration clutch (CL4)
1. Remove the waste toner box.
F.7.6.1 Replacing the waste toner box
2. Remove the transfer belt unit.
F.7.4.3 Replacing the transfer belt unit
3. Remove the front door.
G.5.2.13 Front door
4. Remove the front lower cover.
G.5.2.14 Front lower cover
5. Remove the front cover.
G.5.2.15 Front cover
6. Remove the transport unit.
G.5.3.12 Transport unit
[1]
[2] [3]
8. To reinstall, reverse the order of removal.
5.6.5 1st transfer pressure clutch (CL5)
1. Remove the fusing unit.
F.7.9.1 Replacing the fusing unit
2. Remove the rear right cover.
G.5.2.18 Rear right cover
3. Remove the lower rear cover.
G.5.2.20 Lower rear cover
G DISASSEMBLY/REASSEMBLY > 5. bizhub C368/C308/C258
2. Remove two screws [1], and remove the cover [2].
3. Disconnect the connector [1], and remove the harness from two wire saddles
[2].
4. Remove the E-ring [1], and remove the tray 1 paper feed clutch [2].
NOTE
▪ When mounting the tray 1 paper feed clutch [2], set the convex part
of the stopper into the concave part of the tray 1 paper feed clutch.
7. Remove the E-ring [2]. Disconnect the connector [1], and remove the
registration clutch [3].
NOTE
▪ When mounting the registration clutch, set the convex part of the
stopper into the concave part of the registration clutch [3].
G-63