Konica Minolta bizhub C658 Service Manual page 692

bizhub C658/C558/C458/C368/C308/C258
[1]
[3] [2]
[1] [1]
[2]
12. To reinstall, reverse the order of removal.
8.20.3 Exit tray (FS-537SD saddle section)
[2]
[1]
[3] [1]
[4]
10. Place the right rail [2] to inside the finisher while holding the saddle unit in the
section indicated in the figure [1] and raising it.
NOTE
▪ Place the boss [3] of the saddle unit into the hole in the right rail
when installing the saddle unit.
11. Remove the saddle unit [2] from two tabs [1].
1. Remove five screws [1].
2. Disconnect the connector [2] and remove the left lower cover [3].
3. NOTE
▪ Install after hooking three tabs [4] of the left lower cover when
installing.
G-392
G DISASSEMBLY/REASSEMBLY > 8. Option