CHAPTER 8
Switch Fabric Components and
Descriptions
T4000 Switch Interface Board (SIB) Description
Table 58: T4000 Supported SIB
Name
T4000-SIB
NOTE:
This SIB is required for a
standalone T4000 router.
TXP-LCC-3D SIB
NOTE:
This SIB is required for a
T4000 line-card chassis connected
to a TX Matrix Plus Router.
Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
T4000 Switch Interface Board (SIB) Description on page 79
T4000-SIB Description on page 80
T4000 TXP-LCC-3D SIB Description on page 80
T4000 SIB LEDs on page 81
SIBs create the switch fabric for the T4000 Core Router. Each T4000 router contains
five SIBs, located at the center rear of the chassis in the slots labeled
(top to bottom). One of the five SIBs acts as a backup to the remaining four SIBs. If a SIB
fails, the backup SIB becomes active, and traffic forwarding continues without any
degradation. When the failed SIB is replaced, it becomes the new backup. SIBs are
hot-insertable and hot-removable.
The T4000 router supports the SIB listed in
Model Number
SIB-I-T4000
SIB-TXP-3D-LCC
T4000-SIB Description on page 80
T4000 TXP-LCC-3D SIB Description on page 80
T4000 Router Description on page 3
Table 58 on page
79.
First Supported Junos OS Release
12.1
13.1
through
SIB0
SIB4
79