PTX5000 Packet Transport Router Hardware Guide
Installing a PTX5000 Switch Interface Board
426
Figure 271: Removing a SIB
Each SIB can weigh up to 10.4 lb (4.7 kg). To install a SIB (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place one hand underneath the SIB to support it. With the other hand, hold one of the
2.
ejector handles on the SIB faceplate.
Carefully align the sides of the SIB with the guides inside the chassis.
3.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
4.
Twist the ejector handles clockwise until they stop.
5.
Bring the SIB online using one of the following methods:
6.
Press and hold the
ONLINE/OFFLINE
LED on the faceplate begins to blink. Hold the button down until the LED blinks.
Issue the following CLI command on the packet transport router:
user@host> request chassis sib online slot 0
Figure 272 on page
button on the SIB faceplate. The green
Copyright © 2017, Juniper Networks, Inc.
427):
OK