Replacing Chassis Components; Replacing The Mx960 Craft Interface; Disconnecting The Alarm Relay Wires From The Mx960 Craft Interface - Juniper MX960 Hardware Manual

CHAPTER 22

Replacing Chassis Components

IN THIS CHAPTER

Replacing the MX960 Craft Interface | 433

Replacing the MX960 Cable Manager | 437
Replacing the Console or Auxiliary Cable on an MX960 Router | 439
Replacing the Management Ethernet Cable on an MX Series Router | 440
Replacing an MX960 AS MLC | 441
Replacing an MX960 AS MSC | 446
Replacing an MX960 AS MXC | 449
Replacing the MX960 Craft Interface

Disconnecting the Alarm Relay Wires from the MX960 Craft Interface | 433

1.
Removing the MX960 Craft Interface | 434
2.
Installing the MX960 Craft Interface | 435
3.
Connecting the Alarm Relay Wires to the MX960 Craft Interface | 436
4.
Disconnecting the Alarm Relay Wires from the MX960 Craft Interface
To disconnect the alarm relay wires from the router and an alarm-reporting device (see
Figure 157 on page 434):
1. Disconnect the existing wire at the external device.
2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
433