Replacing a T4000 Craft Interface
Removing the T4000 Craft Interface
Copyright © 2018, Juniper Networks, Inc.
Removing the T4000 Craft Interface on page 249
1.
Installing the T4000 Craft Interface on page 250
2.
CAUTION:
Before you remove the craft interface, remove the upper front fan
tray. See
"Replacing a T4000 Upper Front Fan Tray" on page
To remove the craft interface, see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Completely loosen the screws at the four corners of the craft interface.
2.
Insert the blade of a flat-blade screwdriver into the slot on one side of the craft
3.
interface, then gently pry that side out from the chassis.
Insert the blade of a flat-blade screwdriver into the slot on the other side of the craft
4.
interface, then gently pry that side out from the chassis.
Grasp the craft interface by the top and bottom edges and carefully pull it straight
5.
out of the chassis.
Figure 89: Removing the Craft Interface
FANTR AY-T40 00
Chapter 27: Replacing Chassis Components
Figure 89 on page
249.
267.
249