Configure Subsystem; Configure Subsystem Command Reference - Agilent Technologies N9360A Programming Manual

CONFigure Subsystem

CONFigure Subsystem Command Reference

N9360A Multi UE Tester W-CDMA Programming Manual
This subsystem sets or queries the controls and parameters on
the [Configuration] screen.
Attenuation Control
CONFigure:LOSS ON|OFF|1|0
CONFigure:LOSS?
This command sets the attenuation function to ON (1) or OFF
(0). If this is set to ON, the attenuation function for the radio
systems are activated to be used in the RF input path and RF
output path, respectively. At preset, this is set to OFF.
This query command returns the attenuation function setting
by integer value of or
1
Attenuation Level Setting for Input Signal
CONFigure:LOSS:RFIN <<
<real 1>,<real 2>,<real 3>,<real 4>,<<
<real 5>,<real 6>
CONFigure:LOSS:RFIN?
This command specifies the losses between a mobile phone and
the Tester caused by the RF Input path for each band,<real 1>
Band 1 and <real 6> Band 6, respectively. <real 2>, <real
3>, <real 4> and <real 5> is unused (Set to
allowable range is from
these are set to dB.
0.0
This query command returns the insertion loss setting with real
value. Each value is separated by a comma. The range of these
values is same as that of the command parameter.
Attenuation Level Setting for Output Signal
CONFigure:LOSS:RFOUt <<
<real 1>,<real 2>,<real 3>,<real 4>,<<
Programming Command Reference
.
0
to dB in
0.0 99.9 0.1
5
). The
0.0
steps. At preset,
5-13