Show Ip Pim Rp - Dell Z9500 Command Reference Manual

Version
8.3.11.1
8.1.1.0
7.8.1.0
Usage The following describes the show ip pim neighbor command shown in the
Information
following example.
Field
Neighbor address
Interface
Uptime/expires
Ver
DR prio/Mode
Example
Dell#show ip pim neighbor
Neighbor
Address
127.87.3.4 Te 1/16
Dell#

show ip pim rp

View all multicast groups-to-RP mappings.
Z9500
Syntax
show ip pim [vrf vrf-name] rp [mapping | group-address]
Parameters
vrf vrf-name
PIM-Sparse Mode (PIM-SM)
Description
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Description
Displays the IP address of the PIM neighbor.
List the interface type, with either slot/port information or ID
(VLAN or Port Channel), on which the PIM neighbor was
found.
Displays the amount of time the neighbor has been up then
the amount of time until the neighbor is removed from the
multicast routing table (that is, until the neighbor hold time
expires).
Displays the PIM version number.
• v2 = PIM version 2
Displays the Designated Router priority and the mode.
• 1 = default Designated Router priority (use the ip pim
dr-priority command)
• DR = Designated Router
• S = Sparse mode
Interface Uptime/Expires
09:44:58/00:01:24
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure this setting on that VRF.
Ver DR
Prio/Mode
v2 1 / S
1393