Monitor Multicast-Queue - Dell Z9500 Command Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.7.1.0
7.5.1.0
pre-7.7.1.0
Related
monitor session
Commands

monitor multicast-queue

Configure monitor QoS multicast queue ID.
Syntax
monitor multicast-queue queue-id
To remove the configuration, use the no monitor multicast-queue
command.
Parameters
queue-id
Defaults
queue-id: 0
Enable status: Disabled
Command CONFIGURATION
Modes
Example
Dell(conf)#monitor multicast-queue 7
1436
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— enables a monitoring session.
Enter the QoS multicast queue ID. The range is from 0 to 9.
Port Monitoring