Ipv6 Router Ospf - Dell Z9500 Command Reference Manual

Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.1.(0.0)
8.3.19.0
7.8.1.0
7.4.1.0
Usage
Setting a priority of 0 makes the router ineligible for election as a Designated
Information
Router or Backup Designated Router.
Use this command for interfaces connected to multi-access networks, not point-
to-point networks.

ipv6 router ospf

Enable OSPF for IPv6 router configuration.
Z9500
Syntax
ipv6 router ospf process-id [vrf vrf-name]
To exit OSPF for IPv6, use the no ipv6 router ospf process-id command.
Parameters
process-id
vrf vrf-name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Open Shortest Path First (OSPFv2 and OSPFv3)
Description
Introduced on the Z9500.
Introduced on the S4810 and Z9000.
Introduced on the S4820T.
Added support for the C-Series.
Introduced on the E-Series.
Enter the process identification number. The range is from 1
to 65535.
(Optional) Enter the keyword vrf followed by the name of the
VRF to install IPv6 routes in that VRF.
1353