Show Crypto Ipsec Policy - Dell Z9500 Command Reference Manual

Command
ROUTER OSPF for OSPFv2
Modes
ROUTER OSPFv3 for OSPFv3
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.1.(0.0)
8.3.19.0
7.8.1.0
7.4.1.0
Usage
You can configure an arbitrary value in the IP address for each router. However,
Information
each router ID must be unique.
If this command is used on an OSPFv3 process that is already active (has
neighbors), all the neighbor adjacencies are brought down immediately and new
sessions are initiated with the new router ID.
Related
clear ipv6 ospf process
Commands

show crypto ipsec policy

Display the configuration of IPsec authentication and encryption policies.
Z9500
Syntax show crypto ipsec policy [name name]
Parameters
name name
Defaults No default behavior or values.
Command
EXEC
Modes
EXEC Privilege
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1358
Description
Introduced on the Z9500.
Introduced support for OSPFv3 on the S4810 and Z9000.
Introduced on the S4820T.
Added support for the C-Series.
Introduced on the E-Series.
– resets an OSPFv3 router process.
(OPTIONAL) Displays configuration details about a specified
policy.
Open Shortest Path First (OSPFv2 and OSPFv3)