Monitor Session - Dell Z9500 Command Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.8(0.0)
Related show running-config monitor session
Commands configurations.

monitor session

Create a session for monitoring traffic with port monitoring.
Syntax
monitor session session-ID [type { rpm | erpm [set ip dscp
dscp_value | set ip ttl ttl_value]}] [drop]
To delete a session, use the no monitor session session-ID command.
To delete all monitor sessions, use the no monitor session all command.
Parameters
session-ID
type
rpm
erpm
set ip dscp
dscp_value
set ip ttl
Port Monitoring
Description
Introduced on the S6000, Z9500, S6000-ON.
— displays information about monitor
Enter a session identification number. The range is from 0 to
65535.
Specifies one of the following type:
•
rpm
•
erpm
Creates a remote port monitoring (rpm) session.
Creates an encapsulated remote port monitoring (erpm)
session.
Configures the Differentiated Services Code Point (DSCP)
value of the packets in the Encapsulated Remote Switched
Port Analyzer (ERSPAN) traffic. To revert to the default value,
use the no form of this command.
DSCP value of the packets in the ERSPAN traffic. The range is
from 0 to 63. The default value is 0.
Configures the IP time-to-live (TTL) value of the
Encapsulated Remote Switched Port Analyzer (ERSPAN)
traffic. To revert to the default configuration, use the no form
of this command.
1437