No Snmp - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual

Appendix C Command Summary
Examples
Related Commands

no snmp

Note
Usage Guidelines
Related Commands
78-13124-05
If a single RIP version is not specified, both versions are enabled. Using the no
form of the command disables RIP completely if you do not specify a version to
disable.
The following example activates RIP version 1. The first command enables both
RIP versions. The second command disables on RIP v2. This has the same result
as using the command rip v1.
rip
no rip v2
show rip (Non-Privileged Command Set)
Disables SNMP and clears all SNMP data.
no snmp
The device must be rebooted (reloaded) before this command takes
effect.
Availability: Serial, Telnet; FIPS Mode (serial only)
show snmp (Non-Privileged Command Set)
snmp access-list (Non-Privileged Command Set)
snmp contact (Configuration Command Set)
snmp default community (Configuration Command Set)
snmp enable (Configuration Command Set)
snmp location (Configuration Command Set)
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Configuration Command Set
C-75