Honda 2004 Odyssey Service Manual page 180

9. Move the intake secondary rocker arm (A) for the
No. 1 cylinder. The primary rocker arm (B) and
secondary rocker arm should move together.
If the intake primary rocker arm does not move,
remove the primary and secondary intake rocker
arms as an assembly, and check that the piston in
the primary rocker arm moves smoothly.
A
10. Remove the tools.
11. Tighten the rocker shaft bolts to 24 N·m (2.4 kgf·m,
17 lbf·ft).
12. Install the cylinder head covers (see page 6-34).
2002-2004 models
1. Remove the cylinder head cover (see page 6-34).
2. Set the No. 1 piston at TDC (see step 2 on page 6-
15).
3. Push on the intake mid rocker arm (A) for the No. 1
cylinder. The mid rocker arm should move
independently of the primary rocker arm (B) and
secondary rocker arm (C).
• If the intake mid rocker arm does not move,
remove the mid, primary, and secondary intake
rocker arms as an assembly, and check that the
pistons in the mid and primary rocker arms move
smoothly.
If any rocker arm needs replacing, replace the
primary, mid and secondary rocker arms as an
assembly, and retest.
• If the mid rocker arm moves freely, go to step 4.
B
4. Repeat step 3 on the remaining intake mid rocker
arms with each piston at TDC. When all the mid
rocker arms pass the test, go to step 5.
5. Check that the air pressure on the shop air
compressor gauge indicates over 690 kPa
2
(7.0 kgf/cm , 100 psi).
6. Inspect the valve clearance (see page 6-15).
A
C
B
(cont'd)
6-13