Honda 2004 Odyssey Service Manual page 181

Cylinder Head
VTEC Rocker Arm Test (cont'd)
7. Remove the two end intake rocker shaft mounting
bolts, then install and connect the special tools as
shown.
FRONT:
070AJ-0030100
REAR:
070AJ-0030100
07AAJ-PNAA100
07VAJ-P8A010A
8. Loosen the valve on the regulator, and apply the
specified air pressure.
Specified Air Pressure:
390 kPa (4.0 kgf/cm , 57 psi)
NOTE: If the synchronizing pistons A and B do not
move after applying air pressure, move the primary
or secondary rocker arm up and down manually.
6-14
07AAJ-PNAA100
07VAJ-P8A010A
2
9. Make sure that the intake primary rocker arm (A)
and intake secondary rocker arm (B) are
mechanically connected by the piston and that the
mid rocker arm (C) does not move when pushed
manually. If any intake mid rocker arm moves
independently of the primary and secondary rocker
arms, replace the rocker arms as a set.
B
10. Remove the tools.
11. Tighten the rocker shaft bolts to 24 N·m (2.4 kgf·m,
17 lbf·ft)
12. Install the cylinder head covers (see page 6-34).
A
C